Publicidad
Idiomas disponibles
Idiomas disponibles
1.0 - GENERAL INFORMATION
This manual shows you how to safely install, operate and use the device.
The instructions for use ALWAYS need to be available in the facility where the device is installed.
ATTENTION: installation/maintenance needs to be carried out by qualified staff (as explained in
section 1.3) by using suitable personal protective equipment (PPE).
For any information pertaining to installation or in the event of problems that cannot be solved with the instructions, contact
the manufacturer by using the address and phone numbers provided on the last page.
1.1 - DESCRIPTION
It is a device that allows the tightness of the automatic shut-off valves to be checked before starting a gas burner.
It must be used together with valves that conform to EN 161 and to one or two pressure sensing devices that conform to EN
1854.
The device can be used on gas burner systems for industrial use or for heating use, with or without deaeration ducts for
outdoor discharge.
USE:
Standard EN 1643 (product reference standard) prescribes the use of the valve proving system for powers above 1200kW.
The discharge into the combustion chamber cannot be carried out if the volume of the released gas exceeds 0.05% of the
nominal flow. (E.g. for a nominal flow rate of 150m
If used as an alternative for the pre or post-bleed, the gas discharge into the combustion chamber may not be allowed. The
gas must be released outside in a safe place.
1.2 - KEY TO SYMBOLS
DANGER: In the event
of inobservance, this may
cause damage to tangible
goods.
1.3 - QUALIFIED STAFF
These are people who:
• Are familiar with product installation, assembly, start-up and maintenance;
• Know the regulations in force in the region or country pertaining to installation and safety;
• Have first-aid training.
1.4 - USING NON-ORIGINAL SPARE PARTS
• To perform maintenance or change spare parts (e.g. connector, etc.) ONLY manufacturer-recommended parts can be
used. Using different parts not only voids the product warranty, it could compromise correct device operation.
• The manufacturer is not liable for malfunctions caused by unauthorised tampering or use of non-original spare parts.
1.5 - IMPROPER USE
• The product must only be used for the purpose it was built for.
• The manufacturer is not responsible for any damage caused by improper use of the device.
MTC10
/h the allowed volume is 0.075m
3
DANGER:
In
the
inobservance, this may cause damage
to tangible goods, to people and/or pets.
16
Madas Technical Manual - 9|9.4 - REV. 0 of 8
).
3
ATTENTION: Attention
event
of
is drawn to the technical
details
qualified staff.
intended
for
Feb 2019
th
Publicidad
