Descargar Imprimir esta página

Taurus Striker Mini Guia Del Usuario página 22

Ocultar thumbs Ver también para Striker Mini:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 1
pulse. Once the battery is completely
charged, the battery charging/battery
charged indicator lamp will remain
green (D).
- Approximately 4 hours are needed
for a complete charge of the battery.
Never attempt to over-charge the
battery.
Assembling the battery/s
- CAUTION: During the handling of
batteries, do not touch both poles at
the same time, as this will provoke
the partial discharge of the stocked
energy therefore affecting longevity.
- Make sure the on/off switch is in
the "0" position before installing the
batteries.
- Remove the cover of the battery
compartment.
- Put the battery in its compartment,
respecting the polarity (Fig. 2).
- Close the cover of the battery
compartment.
Assembling the side brushes:
- Place the side brush on the side
brushes holder.
- Press until you hear a click. (Fig.3)
Assembling the mop:
- Insert the edges of the mop into the
coupling clamps in the base for the
mop. (Fig. 4a)
- Adjust the mop holder in the
couplings of the robot body (Fig.4b)
- Remove the mop holder if you are
going to use the robot without mop.
Manual striker mini.indb 22
Instructions for use
Before use:
- Before using this product for the
first time, it is important to make a
full charge of batteries.
Use:
- Turn the appliance on using the on/
off switch.
- The appliance will begin to function
automatically until its batteries run
out.
- While the appliance is operating
the battery charging/battery charged
and battery low indicator lamps will
alternate.
- When the batteries are low, the red
battery low indicator lamp will light
up.
- Remove the platform for mops befo-
re using the robot on rugs or carpets.
- When using the robot on a dark
surface, set the height sensors at
Position 2 or 3. (Fig.11)
Once you have finished using the
appliance:
- Turn the appliance off, using the on/
off switch.
Cleaning
- Disconnect the appliance from the
mains and let it cool before underta-
king any cleaning task.
- Disconnect the charger from the
mains and let it cool before underta-
king any cleaning task.
- Remove the battery before starting
any cleaning operation.
18/03/11 18:00

Publicidad

loading