Transport - ARTROMOT SP3 Instrucciones De Uso

6.3 Transport

The following adjustments need to be carried
out to prepare the ARTROMOT®-SP3 for
transport:
1. Activate the "transport setting" function
in the menu (also refer to 5.3)
and start the ARTROMOT®-SP3.
2. Remove the footplate (7) as well as its
bracket (11). To do so, simply pull it from
the square-end guide at motor B. (Fig. G)
3. For transport of the device, motor B
must be mounted on the right side of
the moving bracket (15) (marked R).
Refer to section 6.4 Conversion, if
required.
4. Turn off the ARTROMOT®-SP3 power
switch.
5. Disconnect the power cord and the
control pendant.
6. Relieve the strain on the carriage by
lifting it a little at the moving bracket
for dorsal extension / plantar flexion
(15) and open the clamping lever which
adjusts the inclination of the carriage
(5). Select an angle where the carriage
is parallel with the adjusted height.
Tighten the clamping lever to lock the
carriage in this position.
7. Again lift the moving bracket for dorsal
extension / plantar flexion (15) a little
to remove the strain. Then loosen the
locking device for the height adjustment
by simultaneously pressing the two
black pins of the locking device together
(19). Select a height where the locking
pins engage in the top hole (marked:
Transport).
8. Only use the original shipping box to
transport the device. Ormed GmbH can-
not be held liable for transport damage,
if the device is not shipped in its original
shipping box.
9. Put the control pendant (22) in the sup-
plied small box.
10. Place the footplate bracket (11) with the
footplate (7) and the power cord in the
extra boxes provided.
11. Place the ARTROMOT®-SP3 on the
bottom of the shipping box. Then pack
the two extra boxes for the control
pendant and the footplate + bracket in
the shipping box along with the padding
material, as shown below.
Extra box with
control pendant
67
Extra box with
footplate/bracket
and power cord