Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
. Operate
pressure washer ONLY outdoors.
. Keep exhaust gas from entering a confined area through
windows, doors, ventilation intakes or other openings.
. DO NOT operate pressure washer inside any holding or
endosure_
The pressure
washer
must be at least 5 ft. (I 52 cm) from
structures
having combustible
walls and/or
other
combustible
materials.
Leave at least 3 ft. (92 cm) all around
pressure
washer
including overhea&
for adequate
cooling,
maintenance
and servicing.
Place pressure
washer
in a well ventilated
area, which will
allow for removal
of deadly exhaust
gas. DO NOT place
pressure
washer
where
exhaust
gas could accumulate
and
enter
inside or be drawn
into a potentially
occupied
building. Ensure exhaust
gas is kept away from any
windows,
doors, ventilation
intakes or other
openings
that
can allow exhaust
gas to collect
in a confined
area
(Figure 8). Prevailing winds and air currents
should
be taken
into consideration
when positioning
pressure
washer.
A
/
/
/
Typical Pressu_ e
Washe_
Shown
Exhaust Port
How
to
StartYour
Pressure
Washer
To start your pressure
washer
for the first time, follow
these
instructions
step-by-step.This
starting
information
also applies if you have let the pressure
washer
sit idle for
at least a day.
I.
Place pressure
washer
near an outside
water
source
capable of supplying water
at a flow rate greater
than
3.2 gallons per minute
and no less than 20 PSI at
pressure
washer
end of garden
hose.
2.
Check that high pressure
hose is tightly connected
to
spray gun and pump. See "Preparing
Pressure VVasher
for Use" for illustrations.
3.
Make sure unit is in a level position.
4.
Connect
garden
hose to water
inlet on pressure
washer
pump. Turn
ON
water.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
5.
Attach
nozzle extension
to spray gun (Figure 9).
Tighten
by hand.
S
6.
Choose desired ProjectPro TMnozzle, pull back nozzle
extension
collar, insert nozzle and release collar.Tug on
nozzle to make sure it is securely in place (Figure I 0).
See "How to Use ProjectPro TMNozzle System".
7.
Engage trigger
loci< on spray gun trigger
(Figure I I).
O
Publicidad
