MBM FTBG74A Manual De Uso E Instalación página 42

the whole surface of the hob and,
using a non-abrasive sponge, clean
the entire surface thoroughly by hand.
When the operation is over, rinse the
hob abundantly with tap water. Have
the drain water flow out through the
specific hole and empty the tank (see
"Deactivation").
When these operations have been
performed successfully, dry the
hob carefully using a non-abrasive
cloth. Set the temperature at the
minimum for about 10' to safely dry
the hotplates. If necessary, repeat the
operations described above for a new
cleaning cycle.
For the parts removed, clean with
detergent and tap water, dry carefully
and reposition in the correct order.
Replace the parts removed in the
correct order (if necessary)
CHROMED HOTPLATES: Use a
resistant plastic scraper to remove
incrustations. Clean the hotplate with
a moist cloth. Turn the appliance on
to dry it (See Daily activation). When
the operations described are finished,
lubricate it with a light coating of food-
safe Vaseline.
OPERATION
Cleaning appliance
Cleaning parts in contact
Cleaning the container
Cleaning at commissioning
Check / Replace gas
Checking thermostat
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
with foodstuff
Cleaning flue
Greasing gas tap
supply pipes
- 18 -
MAINTENANCE
CLEANING FOR PROLONGED
DEACTIVATION / See chapter 5 /
Daily decommissioning / Prolonged
decommissioning.
Air out the appliances and rooms
regularly.
SUMMARISED TABLE /
OPERATION - FREQUENCY
Before proceeding with the ope-
rations, see chap.2 "Duties and
qualifications"
Should a problem occur, the ge-
neric operator performs the first
search and, if qualified, elimina-
tes the cause of the problem and resto-
res the appliance correctly.
If the problem cannot be resol-
ved, turn the appliance off, di-
sconnect it from the electrical mains
and shut all the supply valves. Then
contact authorized customer service.
The authorized maintenance te-
chnician intervenes when the
generic operator was not able to pin-
point the cause of the problem, or
whenever restoration of correct ope-
ration of the appliance entails execu-
ting operations for which the generic
operator is not qualified.
FREQUENCY
In case of need
Upon arrival after installation
Yearly
In case of need
In case of need
Yearly
Daily
Daily
9.
EN