DeWalt D55394 Manual De Instrucciones página 24

CoDE PossIBlE CAusE
31 Water in pump oil
Unloader valve in open position
32
33 Regulator open
34 Possible defective motor or starting capacitor
35 Paint spray on internal motor parts
36 Fuse blown, circuit breaker tripped
PossIBlE solutIon
Drain oil and refill pump with D
Turn unloader valve knob clockwise until it stops.
Rotate the regulator knob counterclockwise to its built-in stop and push
knob in to lock in place.
Contact a D WALT factory service center or a D
e
center.
Contact a D WALT factory service center or a D
e
center. Do not operate the compressor in the paint spray area. See flam-
mable vapor warning.
1. Check fuse box for blown fuse and replace as necessary. Reset circuit
breaker. Do not use a fuse or circuit breaker with higher rating than
that specified for your particular branch circuit.
2. Check for proper fuse. You should use a time delay fuse.
3. Check for low voltage conditions and/or proper extension cord.
4. Disconnect the other electrical appliances from circuit or operate the
compressor on its own branch circuit.
24
WALT synthetic compressor oil.
e
WALT authorized service
e
WALT authorized service
e