PALSON 30595 Modo De Empleo página 14

GB
c) Clean the dirt from the filter (5).
d) Replace the filter (5) into the tank (10).
e) Press down the tab lightly and reinsert the tank (10) into the robotic vacuum.
Cleaning the main brushes (12) on the robotic vacuum.
1. Turn off the robotic vacuum and place it upside down on a flat surface.
2. Use a star-head screwdriver to remove the right attachment screw, then remove the main brush
(12), rubber brush and brush connector, as shown in the following diagrams:
3. Clean the brush chamber and remove any detritus from the brush and rubber brush.
4. Clean off any dirt found on the shaft, the metal connecting bracket and on the brushes (this may
not be necessary after every use) as shown in the following diagrams. Apply lubricant if necessary.
5. Reinstall the brush connector and brushes and tighten the screw.
14
Brush connector