TESY HL-200H Manual De Instrucciones página 3

•
Do not cover the appliance. If the appliance is
covered there is danger of overheating.
•
Do not use the fan heater in the close proximity of
bathroom, shower or swimming-pool.
•
If the electric cord of this appliance gets damaged
you must stop its operation and consult your
supplier/retailer for further instructions.
•
The electrical system to which the appliance is
connected must be provided with automatic safety
fuse. The distance between the sockets and the
appliance (in turned-off state) must be at least 3mm.
•
Grounding is forbidden! After unpacking and before
use you must check if the mechanical parts and
their gear are in a good state. If you have any doubts
you should not use the appliance and search advice
from a qualified electrician.
•
If the appliance is damaged or not functioning
properly you must stop it and not try to repair it
yourself. For any type of repairs you must consult
the Service Center for post-sale help. There you
will have your damaged part replaced with an
original spare one. Not obeying this instruction will
compromise the appliance safety.
•
If you decide to stop using an appliance of that kind
it is recommended to make it unusable as you cut
the electric cord, after you have disconnected it
from the mains. It is also recommended all hazards,
related to the appliance to be checked. That is
very important if there is a chance the discarded
appliance to be used for play by children.
•
You should never keep the appliance unnecessarily
plugged-in. Disconnect the appliance from the
mains if you do not intend to use it for a long time.
•
In order to avoid any overheating of the electric
cord it is recommended to unreel the whole electric
cord.
•
Warning: Do not use this appliance with a
programmer, counter or another device which can
automatically turn it on because if the appliance is
covered or incorrectly positioned there is a danger
of fire.
•
Place the electric cord in such a way that it does
not hamper the movement of people and not
to be stepped on! You must use only approved
connection blocks, which are suitable for the
appliance, i.e. there is a sign of compliance!
•
The electric cord must not be in touch with the hot
parts of the appliance!
English
•
You must never move the appliance by pulling it by
its electric cord. You must never use the electric cord
for moving of other objects.
•
Do not reel the electric cord round the appliance!
Do not use the appliance with its electric cord
reeled – this is also valid if a cable drum is used!
•
Do not press the cord and do not stretch it by sharp
edges. Do not place the cord over hot plates or in
open fire!
PACKAGE
•
After unpacking the appliance you should check if
it is not damaged during transportation and if all
the components are included! In case that you find
out any damage or incomplete package you should
connect with your authorized retailer!
•
Do not discard the original packing box! It could be
used to store the appliance during transportation in
order damages to be avoided!
•
The disposal of the packing material should be
done in the appropriate way! Children should be
prevented from playing with the polyethylene bags!
ASSEMBLY
•
This appliance does not require any special
assembly.
•
The air inlets and outlets of the appliance must
never be covered or hampered!
•
The appliance is intended to be used over
horizontal floor! It is forbidden to be mounted on
wall or ceiling!
•
You must never place the appliance below socket
outlets!
•
The appliance is not suitable to be used in a
bathroom.
MAINTENANCE
•
Summer mode (fan only): Turn the switch
clockwise to position
•
Heating at low power: Turn the switch clockwise to
position "I" (1000W).
•
Heating at high power: Turn the switch clockwise
to position "II" (2000W).
•
Temperature regulation: When the desired room
temperature is reached, turn the switch slowly
clockwise after position "II" until you hear a click.
The set temperature is managed and maintained
automatically via the thermostat.
.
Usage and Storage Instructions
EN
3