GMC DB305SMS Manual De Instrucciones página 13

Trench depth adjustment
• In its normal position, the
Trenching Stop (31) permits the
saw blade to cut right through a
workpiece
• When the saw arm is lifted, the
trenching stop can be moved
to the left so that the Trenching
Depth Adjustment Screw (30)
contacts the stop as the saw
arm is lowered. (Fig. O). This
restricts the cut to a 'trench' in the
workpiece.
• The depth of the trench can be adjusted with the Trenching Depth
Adjustment Screw (30) (Fig. P) and locked in position with the
Trenching Depth Lock Nut (32) (Fig. Q).
P
Setting the table square with the blade
1. Make sure that the electrical plug is removed from the power point
2. Push the Saw Arm (5) down to its
lowest position and engage the
Release Knob (6) to hold the saw
arm in the transport position
3. Loosen the Mitre Lock (25)
(Fig. R)
4. Rotate the table (21) until the
pointer is positioned at 0°
5. Tighten the Mitre Lock (25)
O
Q
R
6. Loosen the Bevel Lock (16) and set the Saw Arm (5) at 0° bevel (the
blade at 90º to the mitre table). Tighten the Bevel Lock (16) (Fig. S)
S
7. Place a set square against the
Table (21) and the flat part of the blade (Fig. T).
Note: Make sure that the square contacts the flat part of the saw blade,
not the teeth.
8. Rotate the blade by hand
and check the blade-to-table
alignment at several points
9. The edge of the set square and
the saw blade should be parallel
10. If the saw blade angles away
from the set square, adjust as
follows
11. Use a 13mm spanner or
adjustable spanner to loosen the
lock nut securing the 0° Bevel
Adjustment Screw (35) (Fig. U).
Also, loosen the Bevel Lock (16)
12. Adjust the 0° Bevel Adjustment Screw (35) with the 6mm hex key to
bring the saw blade into alignment with the square (Fig. V)
V
13. Loosen the 2 Phillips head screws holding the pointer of the Bevel
Scale (17) and adjust the position of the pointer so that it accurately
indicates zero on the scale (Fig. W). Retighten the screws
13
T
U
W
GB