6 Pet Hair Turbine Tool; 6 Agitator Maintenance; 6 Replacing The Agitator Belt - LG LuV350P Serie Manual Del Propietário

16
CARE & CLEANING
Pet Hair Turbine Tool
To clean the pet hair turbine tool:
1. Remove the four screws on the bottom of the pet hair turbine tool.
2. Lift off the cover.
3. Remove any debris.
To reassemble:
4. Carefully press the cover onto the tabs until they snap into place.
5. Insert and tighten the screws that were removed in step 1. Do NOT
overtighten the screws.
Do Not use the pet hair turbine tool on animals.
WARNING
y Electrical shock and personal injury hazard.
y Always unplug the power cord from the electrical outlet
before servicing.
y Failure to do so could result in electrical shock or personal
injury.
Agitator Maintenance
Frequently check the agitator brush area for hair, string and line buildup.
Remove the Agitator Brush Cover:
1. Unplug the vacuum cleaner. Press the left foot pedal to release the
head. Lower the handle until the vacuum cleaner is lying flat on the
floor.
2. Turn the vacuum cleaner so that the agitator is facing up.
3. Set the head on a cloth or a smooth surface. Remove the six screws on
the bottom of the head and remove the cover.
4. Carefully remove any accumulated string, hair, etc. from the agitator
and the agitator area.
To reinstall the cover, reverse the steps above.
WARNING
y Electrical shock and personal injury hazard.
y Always unplug the power cord from the electrical outlet
before servicing. Failure to do so could result in electrical
shock or personal injury.
Replacing the Agitator Belt
If the belt breaks, follow the steps below to replace the agitator belt.
To Replace the Belt:
1. Remove the agitator brush cover.
2. Lift the agitator straight out.
3. Unhook the old belt from the drive pulley. Make sure no pieces of the
broken belt are trapped in the agitator or drive pulley area.
4. Hook the new belt over the drive pulley of the agitator motor.