Rollei HS Freeze 6 Manual De Instrucciones página 25

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 52
Quick Menu
Press the second function button from the left and turn the power output
CH
button to adjust the channel number . This can be set from 00 to 15 .
Press the third function button from the left and turn the power output
GR
button to adjust the group . Here you can choose between A/B/C/D/E/F .
Press the fourth function button from the left to set the Canon* ID number
ID
between 00 and 99 . The flash and Canon speedlites can be synchronized if
the channel and the ID numbers are the same .
Press the second function button from the left side to activate the beep .
Here you can turn the function on and off . If this is turned on, the flash will
make indication sounds and the icon is shown on the display .
Photo cell: Press the third function button from the left side to activate or
deactivate the photo cell function . If this function is activated, the icon will
be shown on the display . The flash is then able to release a flash strobe as
soon as another flash is fired . For this function the infra red sensor should
not be hidden .
Modeling lamp: Press the fourth function button from the left to activate
the modeling lamp . Press it once for the proportion mode [
modeling lamp will be limited in its intense like the flash power has been
set . Press the button again to enter the independent mode [
you can set the power of the modeling lamp individually from 1 .0 to 9 .0 by
turning the power output knob . To deactivate the modeling lamp press the
power on/off button .
ID
25
PRO] and the
1 .0] in which

Publicidad

Tabla de contenido
loading

Tabla de contenido