Publicidad
Idiomas disponibles
Idiomas disponibles
10
English
GB
Important:
Before attaching ensure that
sufficient space remains for air
to circulate through the radiator
grille (engine cooling).
Mount both lamps above the
bumper. The lamps must not
vibrate, must not jut out above
the hood, and must be
attached symmetrically.
See page 2 for
installation steps.
Installation dimensions for additional headlamps.
max.
4 m
Tools required:
• Crimp terminal pliers
• Ruler
• Hex key = dia. 3 mm,
dia. 6 mm
• Open-end wrench, 17 mm
• Drill with bits, dia. 3 mm,
dia. 11mm, dia. 12 mm
• Combination pliers
max.
4 m
Mark and drill the mounting
point for the headlamp base
on a stable surface.
Seal drilled hoes with rust
protection!
The headlamps are designed
only for upright attachment!
Screw the headlamp base
tightly onto the mounting
surface.
Changing bulbs:
Screw housing apart and
replace the light source.
Caution:
During assembly ensure that
the spiral cable is located
"within" the inner sealing
ring, as otherwise moisture
can penetrate.
Publicidad
