Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
belt adjustment
4.
When the user is properly seated in the wheelchair, position the belt across the
pelvis and attach the strap to the Guide Plate as shown in Fig. 4.
5.
Tighten the strap in place making sure the belt is comfortably sitting around the
pelvic area (adjust each strap evenly so the buckle is in the middle) and that there
is no more than 3" (75mm) of strap coming from the buckle to the 'D' Ring.
6.
Grab the two ends and buckle the belt.
7.
Attach both of the 1" straps to the harness (Fig. 5) and fit the strap to the Guide
Plate as shown in Fig. 4 so that the straps are not too tight.
8.
Tension the belt by pressing on the end of the buckle (Fig. 6) and pull on the 'D'
Ring until the belt is not too loose to be ineffective nor too tight to cause discomfort.
Poziform
EN - aSSEMblY INSTRUcTIONS
Figure 5
5
Figure 4
Figure 6
Publicidad
Tabla de contenido
