To Stop The Product; To Operate The Product; Maintenance; Maintenance Schedule - Husqvarna 525HF3S Manual Del Usuario

Note: To start the product when the engine is warm, it is
not necessary to use the choke control.

To stop the product

• Move the stop switch to the stop position to stop the
engine.
CAUTION: The stop switch automatically
goes back to run position.

To operate the product

• Start near the ground and move the product up
along the hedge when you cut the sides.
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.

Maintenance schedule

Maintenance

Clean the external surface.
Clean the muffler, exhaust pipe and engine from leaves, dirt and unwanted lubri-
cant.
Make sure that the cutting unit does not move at idle speed.
1118 - 001 - 05.09.2019
• Adjust the speed to align with the work load.
• Make sure that the engine does not touch the hedge.
• Hold the product near your body for a stable work
position.
• Make sure that the tip of the cutting equipment does
not touch the ground.
• Be careful and work slowly until all the branches are
correctly cut.
Maintenance
Before After 40
operation h
After each operation.
After each operation.
X
After 100
h
11