Omega PB-2103 Manual De Instrucciones página 16

EN
4. Remove the pin and remove the
movable blade.
7. Replace the blade.
NOTE: Shim and moving blade can be replaced independently. When doing so, don't be afraid of too small a blade opening. After electricity, the normal aperture
size will automatically recover.
Pruner maintenance:
1. Do not cut the branch outside the cutting range; do not cut non-plant materials such as metal and stone etc. Do not use a vice
to hold tools. Replace a shear blade if it is worn or damaged.
2. Keep the equipment clean, wipe the pruning shears, batteries and chargers with a clean cloth (do not use corrosive detergents
or solvents) and use a soft brush or dry cloth to remove dust.
3. Do not immerse pruning shears, batteries, and chargers in water or other liquids
4. Use the equipment correctly. Stop using them when there is any damage to the pruning shears, batteries, chargers, etc.
5. If the power switch does not work normally or the pruning shears cannot be turned off, do not use them. They will be dangerous
to control without a switch and must be repaired.
6. Make sure the switch is off when replacing accessories or storing pruning shears. Such a preventive measure will reduce the
risk of accidentally turning on the pruning shears.
7. Close the blades of the pruning shears and keep them out of the reach of children. It is dangerous to allow inexperienced
people and untrained users to use them.
8. When using pruning shears, respect the tools and use, and consider the work environment and tasks. It can pose a risk if
pruning shears are used for irregular operation.
9. After use, remove the dirt from the blades, add lubricating oil or motor oil to the contact part, make the blade keep in the normal
maintenance state, and reduce and extend the life of the blade for the next use .
5. Remove the fixed blade.
8. Insert hut.
6 6
6. When replacing the blades, lubri-
cating oil must be added between
them.
9. Install the nut lock tab.