10. To turn off the coffeemaker at any time, press the power button
CAUTION: The coffee POD will be hot.
11. When cooled, carefully remove and dispose of the used POD.
BR E W I N G S I NGLE S E RV E—GR O U N D COF FEE
1. Make sure your Café Select™ is in ready mode and the
power button LED
2. Ensure the water reservoir is filled with a minimum
of 20 ounces of water. Do not fill reservoir past the
MAX fill line.
IMPORTANT: If you attempt to brew a single serve
selection with less than 20 ounces of water in the
reservoir, the six brew selection buttons will flash
several times to alert you to add more water.
3. Open the filter basket lid above the single serve spout.
4. Place the grey ground coffee adapter into the cavity
inside the unit. (E)
5. Fill the reusable grey single serve filter with your
desired amount of coffee grounds, one tablespoon
per brewed cup or to taste. (F)
6. Close reusable filter lid and place it into the ground
coffee adapter. (G)
7. Push the single serve filter basket lid down until it
locks in place. (C) This will ensure the filter basket lid
does not lift open during brewing.
8. Adjust the drip tray so that it holds your coffee mug close to
the single serve spout. Place your mug on the drip tray. (D)
9. If your coffee mug is too tall to fit on the drip tray, remove
the drip tray and place your mug on the unit's base. (H)
10. To start the brew cycle, press your choice of brew
size: 6, 8, 10, 12, 16, or 20 ounces.
NOTE: The brew cycle for 12, 16, or 20 ounces pauses
mid-cycle and restarts. The brew selection light turns off
when brewing is complete.
11. To turn off the coffeemaker at any time, press the
power button
12. When cooled, carefully dispose of the used grounds
and wash the reusable filter for future use.
is lit. (See Before Brewing.)
.
11
.
E
Place ground coffee adapter.
F
6
8
Add grounds to filter.
G
Tanque de agua
Place filter into adapter.
H
Place tall mug without tray.
10
12
Removab
water res