Kohler K-1111-VLN Guia Del Propietario página 5

Activates Mode
Selected
Backjet Mode-
Adjust Pulse
Rotate outer
ring to access
desired mode.
Chromatherapy -
Specific Color
User Keypads
Available modes will be illuminated in blue. Active modes will be illuminated in green.
Turns the whirlpool pump on and off. Icons illuminated in blue indicate available
Power Icon
modes/features. Modes which are operating will be illuminated in green.
Chromatherapy Rotate the outer ring to select this mode. Press OK, press the up or down arrow to select a
Specific Color color, then press OK again. Only one of the two keypads controls this mode.
Outer Ring Rotate the outer ring to the desired mode. The selected mode will flash blue.
Backjet Mode Rotate the outer ring to select this mode. Press OK, then press the up or down arrow to
increase or decrease the pulsing action. Rotate the outer ring to the Flexjet mode, press OK
to activate the mode, then press the up or down arrow on the keypad to increase or
decrease water flow to the backjets and all other active modes.
OK Activates the desired mode.
Flexjet Flow Rotate the outer ring to select this mode. Press OK, then press the up or down arrow to
increase or decrease the jet water flow.
Mode
Up Arrow Increases the water flow when the Flexjet flow mode is active. Increases the pulse speed
when the neckjet or backjet mode is active.
Rotate the outer ring to select this mode, then press OK. The effervescence action will start
Effervescence
Mode at the water flow volume last set in the Flexjet flow mode. Press the up or down arrow to
increase or decrease the water flow. Press OK while the effervescence mode is flashing to
turn off the effervescence ports.
Indicator Bar Displays the water flow volume in the Flexjet flow mode. Displays the pulse speed in the
neckjet or backjet mode.
Chromatherapy Rotate the outer ring to select this mode, then press OK. The chromatherapy lights will
automatically and continuously cycle through eight colors. One cycle through all eight
Cycle
colors takes approximately one minute. Only one of the two keypads controls this mode.
Down Arrow Decreases the water flow when the Flexjet flow mode is active. Decreases the pulse speed
when the neckjet or backjet mode is active.
Heater Automatically engages when the power icon is selected. Rotate the outer ring until the
heater mode is flashing, then press OK to turn the heater off. Press OK again to turn the
heater back on.
Kohler Co.
Flexjet Flow Mode
Power
On/Off
Heater On/Off
Lighted User Keypad
Increases Flow
or Pulse Rate
Effervescence
Mode
Indicator Bar - Shows
Water Flow Volume or
Pulse Rate
Chromatherapy
Cycle
Decreases
Note:
Flow
5
Keypad above shows all features
available. Your keypad may vary
based on your whirlpool model.
1042760-5-D