Auto-Reconnection; DisplayingTheTelephoneMenu - Jensen MP1514BT Manual Del Propietário

5. At this point a prompt stating that pairing is successful should appear.
Another prompt should appear asking connect to the unit, Yes or No. Press
Yes. The mobile phone and the unit should connect. The mobile phone should
display a message similar to "Device Connected. " The mobile phone and the
unit are now connected.
When successfully paired, "BT AUDIO" and the Bluetooth
on the display panel.
Note: If pairing fails, try to pair again within several seconds. Refer to the mobile
phone's instruction manual. Delete the device that you just searched for and
re-pair again.
Note: During pairing, only the
and MUTE button are functional. The other buttons are disabled during
pairing mode.
Note: If you want to exit pairing mode while pairing, press and hold the MODE/
PAIR button until "PAIR END" appears on the display panel.

Auto-Reconnection

This unit has a built-in auto-reconnection function. In some conditions, the unit
will auto reconnect with the mobile phone (note: the mobile phone must have
been paired with the unit before.)
Before dialing, you need to confirm that the Bluetooth
display panel within ten seconds of the following conditions:
• When you turn off the unit and then turn it on again.
• Switch off the ACC wire and switch it on again.
• Press the (release) button to release the front panel and install the
panel again.
If you press the
wait for several seconds to let the unit reconnect automatically or press and hold
the CONNECT button for several seconds to reconnect. During reconnection, the
display panel will show "CONN TRY" several times and then show "CONN OK" if the
connection is successful.

DisplayingtheTelephoneMenu

1. When pairing is successful, press and hold the DISP button on the front panel
enter the telephone menu.
2. Keep pressing the DISP button or press the
items in this menu. The items will be displayed in the following sequence:
RECEIVED
The telephone menu items are listed below:
• RECEIVED: Displays the calls you have received.
Rotate or press the volume knob to scan the last received numbers. Press
the button to dial the number.
40
(Release) button, volume up/down buttons
button, 'NOT PAIR' may appear on the display panel. You can
DIALED MISSED
symbol appears on the
or buttons to select the
MANU ANS TALK XX.
symbol appears
/