Kreg PRS2100 Manual De Instrucciones página 6

5.
30
29
28
32
31
33
34
36
Benchtop Router Table Assembly Instructions
35
35
34
37
Step 10
Assemble the bit guard (#30) using two ¼-20 x 1¼" T-bolts (#31), two
spacers (#32), two ¼" brass fl at washers (#28), and two T-knobs (#29),
as shown. Slide the T-bolt heads into the T-slot at the top front edge of
the fence extrusion and tighten the knobs.
Step 11
Assemble the cam clamps using the cam posts (#33), cam levers (#34),
¼-20 x 2½" Phillips panhead machine screws (#35) and clamp anchors
(#36). Snap the cam posts onto the cam-lever studs. Slip the machine
screws through the posts and drop the lever/post/machine screw
assemblies through the holes in the base fl ange of the fence extrusion.
Thread the machine screws into the clamp anchors until the tips of the
anchor "fi ngers" engage the notches in the cam posts. [Because the anchor
fi ngers engage the post notches, the anchors can't turn and bind in the
table-top slots or change the cam-clamp tension.]
Step 12
Mount the assembled fence on the router-table top by dropping the clamp
anchors (#36) through the key holes in the table top. With the cam levers
(#34) fl ipped up in the vertical position and the lobes resting in the round-
bottom groove in the fence extrusion, slide the fence forward, engaging the
clamp anchors in the table-top fence slots. To adjust cam-clamp tension,
fl ip the cam levers down into the horizontal position. Tighten the machine
screws (#35) with a screw driver until the clamps are tight enough to hold
the fence in place. Now when you lift the levers to release the fence, it
should move freely.
Step 13
To store the jointing rods (#37), slide them into the round channel at the
back edge of the base fl ange of the fence extrusion. For instructions on
how to use these rods for jointing on your router table, see JOINTING
under the section USING YOUR ROUTER TABLE.