BONFIGLIOLI Vectron AEC Guia De Inicio Rapido página 25

1 General
This documentation describes the first steps for easy commissioning of AEC series mains units.
The AEC series can be recognized by its label on the case and the identification below the top cover.
1.1 Safety
WARNING
• The safety instructions and information on use in this documentation must be complied with
strictly.
• Read this documentation before installing and commissioning the mains unit.
• Non-compliance with the precaution described may result in death, serious injury or material
damage.
• Only qualified personnel trained in installation, commissioning and operation of mains units may
carry out work on the mains units.
• The electrical installation must be carried out by qualified electricians according to the general
and regional safety and installation directives.
• Persons who are not familiar with the operation of the mains unit and children must not have
access to the device.
• Comply with the standards for work on equipment of heavy current installations such as EN
50178 and also with national accident prevention regulations and directives for electrical and
mechanical equipment erection.
• Before commissioning and the start of the operation fix all covers, assemble all components of
the standard equipment and check the terminals.
• No connection work may be performed, while the power supply is switched on.
• Do not touch terminals before capacitors have discharged.
• Do not touch the heat sink during operation as there is a risk of skin burn due to high
temperature.
•
Do not remove covers during operation.
• Please note, that Bonfiglioli Vectron does not take any responsibility for the compatibility of
external products (e.g. motors, cables, filters, etc.). Using the device in combination with
external products is carried out at your own risk.
• Do not touch electronic components or contacts.
• Do not operate damaged or destroyed components.
06/13 Quick Start Guide AEC
(Position of ID
depends on size)
GB
25