Vent Safety Shutoff System; Proper Main Burner Flame; Proper Pilot Flame - Empire Heating Systems GWT-50W-2 Manual Del Propietario Y Instrucciones De Instalación

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

This appliance must be properly connected to a venting system. This

appliance is equipped with a vent safety shutoff system.

Warning: Operation of this wall furnace when not connected

to a properly installed and maintained venting system or

tampering with the vent safety shutoff system can result in

carbon monoxide (CO) poisoning and possible death.

This furnace is equipped with a manual reset vent safety switch. The

manual reset vent safety switch will cause gas flow to the main burner

to "shut off" due to improper venting or a blocked flue.

To reset the manual reset vent safety switch:

1. Remove outer casing.

2. Depress manual reset button. The manual reset vent safety switch

is located on the draft diverter.

3. Replace outer casing.

If the manual reset vent safety switch continues to "shut off" the gas

flow to the main burner a qualified service person must be contacted to

inspect for improper venting, blockage in the vent pipe or the manual

reset vent safety switch for being defective.

The correct flame will be a short blue inner flame with a much larger light

blue outer flame. The burner does not have a primary air adjustment.

The flame will be proper if the factory-set pressure and orifice are used.

After the furnace has begun operating, cleaning of the burner may be

needed for proper flame, examine at least 2 times per season.

To clean burner ports, disconnect the gas supply to the valve. Remove the

burner assembly from the combustion chamber. Remove pilot burner from

main burner and then remove the main burner. Force water into the ports

and blow dry with vacuum cleaner air, or low pressure compressed air.

The correct flame will be blue, extending past the thermopile. The flame

will surround the thermopile just below its tip.

Natural Gas pilots require adjusting when the inlet gas pressure is above

5" w.c. (1.245kPa). Remove the pilot cover screw on the control valve

and turn the adjustment screw clockwise to reduce flame. Replace

pilot cover screw to eliminate gas leaking at that control valve opening.

Propane Gas will not require adjustment.

After use, cleaning may be required for the proper flame.

Examine the pilot flame before and during each heating season.

Page 14