Craftsman CMXGZBF7124322 Manual De Instructiones página 4

ENglISh
ASSEMBLY
Step 1: (Fig. 1)
1. Insert each side of the axle of the impeller assembly into
the frame tube.
2. Insert two hex flange bearings (I) into the frame tube.
Fig. 1
INDENTED
END
I
Step 2: (Fig. 2)
1. Attach hopper to frame tube using two 1/4" x 1-1/2"
hex bolts (A), 1/4" washers (G), and 1/4" nylock nuts (D).
Tighten.
2. Insert an 1/8" hair cotter pin (E) into the hole at the top
of the impeller
Fig. 2
E
A
G
D
2
I
A
G
D
Step 3: (Fig. 3)
1. Slide a spacer (J) over the right side of the axle.
2. Attach the drive wheel (9) to the right (indented) side of
the axle. Secure wheel in place with a hub cap (K)
3. Verify correct wheel is assembled before securing with
hub cap. Assembling wrong wheel will prevent further
assembly
Fig. 3
INDENTED
DRIVE
BRACKET
K
Step 4: (Fig. 4)
1. Slide a spacer (J) over the left side of the axle.
2. Attach the wheel (10) to the left side of the axle. Secure
the wheel in place with a hub cap (K)
Fig. 4
END
J
9
J
10
N
K