Craftsman CMXGZBF7124322 Manual De Instructiones página 5

Step 5: (Fig. 5)
1. Assemble the (RH) and (LH) hitch tubes to the control
tube using two 1/4" x 1-3/4" hex bolts (B) and 1/4"
nylock nuts (D). Tighten.
2. Assemble the plastic caps onto the ends of the hitch
tubes and control tube.
Fig. 5
F
B
Step 6: (Fig. 6)
1. Attach the (RH) and (LH) hitch tubes to the frame tube
using four 1/4" x 2" hexbolts (C) and 1/4" nylock nuts
(D). Tighten..
Fig. 6
C
F
F
D
D
D
Step 7: (Fig. 7)
1. Assemble the control cable to the hitch control tube
using the carriage bolt and nylon wing nut. Do not over
tighten.
2. NOTE: See ADJUSTING THE FLOW RATE SETTING on
page 4
Fig. 7
Step 8: (Fig. 8)
1. Assemble the hitch brackets to the hitch control tube
using two 1/4" x 1-3/4" hex bolts (B) and 1/4" nuts (D).
Tighten.
2. Assemble the hitch pin (H) through the hitch brackets
and secure with the 1/8" hair cotter pin (E)
Fig. 8
ENglISh
B
H
D
E
3