Craftsman CMXGZBF7124322 Manual De Instructiones página 6

ENglISh
OPERATION
Adjusting the Flow Rate Setting
• Loosen the wing nut that fastens the flow control lever
to the handle.
• Slide the adjustable stop to the desired setting and
retighten the wing nut. See figure 9.
Fig. 9
FLOW CONTROL LEVER
ADJUSTABLE STOP
Spreading Material
• Check the material package for the proper spreader
setting and application rate.
• Before filling spreader, move the control lever to the
"OFF" position.
• Move spreader onto a flat surface - either a walk or a
driveway - and fill.
• Slide the adjustable stop to the desired setting.
• Start the spreader in motion, then move the control
lever forward against the adjustable stop to begin
spreading.
• NOTE: Always place control lever in the "OFF" position
while filling spreader and when stopping or turning, to
prevent release of excess fertilizer..
• DO NOT EXCEED 6 MPH WHILE TOWING SPREADER
Application Tips
• This unit will cover a 4 to 8 foot wide area depending on
the material used and the towing speed.
• To avoid misses or striping, make each pass about 5 feet
from the previous one so some overlapping of spread
pattern does occur.
• For easiest application, spread across the shortest edges
of lawn first, making two "header" strips for a turning
area, and then spreading between the header strips.
See figure 10.
• If lawn is odd shaped, spread a border around the edges
and then spread between the border. See figure 10.
• Keep wheel approximately 4 feet from any area you do
not wish to spread.
• IMPORTANT: Be careful when using spreader around
ornamental plants because weed control chemicals can
damage these plants.
4
TYPE
MATERIAL
FERTILIZER
Granular
Pelleted
GRASS
SEED
WING NUT
Fine
Coarse
ICE MELTER
IMPORTANT: Minor setting adjustments may be necessary
to compensate for humidity and moisture content of the
material.
Fig. 10
MAINTENANCE
Check For Loose Fasteners
• Make a thorough visual check of the Spreader for any
bolts and nuts which may have loosened. Retighten any
loose bolts and nuts.
Lubrication
• Apply a few drops of oil to all moving parts....
Cleaning & Storage
• Always empty spreader after each use, storing leftover
material in it's original bag.
• Wash the spreader and dry thoroughly after each use.
• Store in a dry area.
APPLICATION CHART
FLOW
SETTING
3 - 5
3 - 5
3 - 4
4 - 5
6 - 8
SPREAD
WIDTH
8' - 10'
10' - 12'
6' - 7'
8' - 9'
10' - 12'