Yamato TDU 210PS Manual De Instrucciones página 18

cod.92004 – TDU 210PS
• Use exclusively the type of saw blade that is recommended by the manufacturer and complying that
meets the requirements of EN 847-1.
• Do not saw any other materials than wood, wood products, aluminium and plastic.
• Select the correct saw blade for the work piece to be sawn.
• Connect the dust extraction device before starting the operation.
When using the machine in the table saw position, always make sure that the riving knife has been
•
adjusted properly.
When using the machine in the table saw position, always use the push stick to guide the work piece
•
along the saw blade.
When using the machine in the cut-off saw position, check that the upper part of the saw blade is fully
•
covered by the upper guard.
When using the machine in the table saw position, check whether the upper table top is tightened firmly.
•
Always unplug the machine before performing any maintenance.
•
Do not use the machine before it has been completely assembled and installed according to the
•
instructions.
Do not perform any design, assembly or construction activities on the table while the machine is switched
•
on.
Unplug the machine and clean the table before leaving the work area.
•
Residual risks
The following hazards may occur during the operation of this machine:
• danger of injury to the fingers and hands while changing the saw blade
• danger of injury through flying debris from the workpiece
• danger of hearing damage
• health risk due to inhalation of airborne particles
DESCRIPTION (fig. A1 & A2)
Your table saw/cut-off saw has been developed for sawing wooden work pieces. The machine is not suitable
for sawing grooves, etc.
1 On/off switch (cut-off saw position)
2 Operating handgrip
3 Lock-off button
4 Lock screw upper table top
5 Dust extraction connection
6 Lock knob bevel angle
7 Scale for bevel angle
8 Head lock down knob
9 Lock knob mitre angle
10 Scale for mitre angle
11Mounting hole
12 Lower table top
13 Guide fence
14 Saw blade guard
15 On/off switch (table saw position)
16 Lower guard
17 Guide fence
18 Upper table top
19 Upper guard
Mounting the machine (fig. A1)
The machine must be screwed to a workbench.
Mark the position of the mounting holes (11) on the workbench.
•
Drill holes at each of the marked positions, adjusting the diameter and depth of the holes to the screws
•
used.
Place the machine on the workbench and insert the screws into the mounting holes.
•
Firmly tighten the screws.
•
18