Ecco 13 Serie Instrucciones De Instalación Y Funcionamiento página 2

!
WARNING!
Failure to install or use this product according to manufacturer's recommendations may result in property
damage, serious bodily/personal injury, and/or death to you and those you are seeking to protect!
Specifications:
Length
Height
Voltage
Current Draw
Flash Patterns
Sequence
1
2
3
4
5
6
7
8
9
10
11
Functionality, Installation & Mounting:
Functionality:
1. Flash Patterns
To change the flash pattern:
1.1 Have the L/bar flashing on the pattern that is to be changed.
1.2 Double tap Pattern Select Violet wire to positive, to unlock the functionality.
1.3 Every single tap between 0 and 1 sec will increment the pattern and between 1 and 5 sec will decrement it, accordingly to the
Flash Pattern Table.
1.4 Last selected pattern will be saved.
1.5 Violet wire functionality will be locked if not used for 60 seconds.
2. Centre Illumination
To turn centre illumination On, connect the Blue wire to positive voltage supply e.g. tail lights.
2.1 Without providing main power via Red wire* to the L/bar, illumination will take approx 0.1 Amp per each illumination module
through the Blue wire.
2.2 With the power present, current will be taken via the Red wire, while Blue will serve as driving signal only, taking approx 0.1
Amp.
* Negative supply/Ground needs to be permanently connected to the Black wire.
Mounting
Before proceeding with installation, plan all wiring and cable routing. Select the mounting location for the lightbar on a flat, smooth
surface and center the unit across the width of the vehicle. The mounting location for the lightbar should be chosen such that the
lightbar is level and visibility to approaching traffic is optimized.
!
Caution:
When drilling into any vehicle surface, make sure that the area is free from any electrical wires, fuel lines, vehicle upholstery,
vehicle support members, etc. that could be damaged.
Page 2 of 6
P/N 920-0647-00 (Rev C) 2018-12-03
770mm (30")
85mm (3.3")
12-24VDC
Single LED ( Class I ) =
Single LED ( Class II ) =
Double LED ( Class I ) =
Double LED ( Class II ) =
Control Illumination =
10 (See chart)
Available Flash Pattern Chart
Description
Reg 65 Single
Reg 65 Double 123 FPM
Reg 65 Triple 123 FPM
Reg 65 Quad 123 FPM
Reg 65 8 Burst 123 FPM
Reg 65 Single Alternate 123 FPM
Reg 65 Double Alternate 123 FPM
Reg 65 Triple Alternate 123 FPM
Reg 65 Quad Alternate 123 FPM
Reg 65 8 Burst Alternate 123 FPM
Cruise/Steady Burn
Specifications:
1000mm (39")
Width:
0.30A Avg. @ 12VDC
0.80A Avg. @ 12VDC
0.40A Avg. @ 12VDC
1.20A Avg. @ 12VDC
0.10A Avg. @ 12VDC
Class II
FPM Class I
(Available upon
N/A N/A








N/A
N/A N/A
1250mm (49") 1500mm (59")
200mm (7.9")
Per Module
Notes:
EZ0006 Controller
available for bars
request)
fitted with control
N/A
cable only.








N/A
N/A