CPV 2x Serie Manual Del Usuario

2x Series Lightbar (with 3 or 4 Wires and Black Tops)
IMPORTANT NOTICE TO INSTALLER: Make sure to read and understand
all instructions and warnings before proceeding with the installation of this
product. Ensure that the manual and any warning cards are delivered to the
end user of this equipment. Proper installation of the lightbar requires the
installer to have a thorough knowledge of automotive electronics, systems,
and procedures. Lightbars provide an essential function of an effective visual
warning system. The use of the lightbar does not ensure that all drivers can
or will abide by or react to an emergency warning signal, especially at high
rates of speeds or long distances. The operator of the vehicle must never take
the right of way for granted and it is the operator's responsibility to proceed
safely. The effectiveness of the lightbar is highly dependant on the correct
mounting and wiring. The installer must read and follow the manufacturer's
installation instructions and warnings in the manual. The vehicle operator
should verify daily that the lightbar is securely fastened to the vehicle and
properly functioning before operating vehicle. The lightbar is intended for use
by authorized personnel only. It is the user's responsibility to ensure they
understand and operate the emergency warning devices in compliance with
the applicable local, state and federal laws and regulations. SoundOff Signal
assumes no liability for any loss resulting from the use of this warning device.
Components/Contents
Standard Equipment:
1 - 2X Series Lightbar, with 3 or 4 wires and black tops
2 - Mounting Foot with hardware
**Vehicle specific hook kit not included
Unpack Lightbar
1. Remove the lightbar from box and packaging.
2. Save packaging for later shipping.
3. Check components/contents.
4. Please reference these instructions for proper wiring and installation.
Tools Required for Installation
• 13mm Socket with ratchet
• 13mm Wrench
• Phillips Head screwdriver
1.616.662.6199 / www.soundoffcvp.com
Installers and users must comply with all applicable federal, state and local laws regarding use and installation of warning devices.
Improper use or installation may void warranty coverage. To review our Limited Warranty Statement & Return Policy for this or any SoundOff Signal product, visit our website at
www.soundoffcvp.com/sales-support. If you have questions regarding this product, contact Customer Service, Monday - Friday, 8 a.m. to 5 p.m. EST at
S U P E R I O R C U S TO M E R R E L AT I O N S H I P S . S M A RT LY D E S I G N E D L I G H T I N G & E L E C T R O N I C S O L U T I O N S .
1.
Questions or comments that do not require immediate attention may be emailed to
orders@soundoffcvp.com.
TABLE OF CONTENTS
PAGE
1 COMPONENTS/CONTENTS
2 POWER/TECHNICAL SPECIFICATIONS
3
4 INPUT WIRE DEFINITIONS & FLASH PATTERN/
TAKEDOWN/WORK LIGHT CONFIGURATION
5 LIGHT MODULE REPLACEMENT &
6 WARRANTY AND RETURN GOODS PROCEDURE
Important Information:
• Warning devices are strictly regulated and governed by Federal, State
and Municipal ordinances. These devices shall be used ONLY on approved
vehicles. It is the sole responsibility of the user of these devices to ensure
compliance.
• DO NOT install this product or route any wires in the Air Bag Deployment
Zone. Refer to your vehicle Owner's Manual for the location of any air
bag deployment zones.
• DO NOT connect this device to a strobe power supply. This product is
self-contained and does not require an external power supply.
!
This product contains high intensity LED devices. To
prevent eye damage, DO NOT stare into the light
NOTICE:
CONTENT
MOUNTING
TROUBLESHOOTING
WARNING
beam at close range.
1.616.662.6199
Series 2Xwith3or4WiresAndBlackTops 1017
.