Publicidad
Idiomas disponibles
Idiomas disponibles
2x Series Lightbar (with 3 or 4 Wires and Black Tops)
Power Cable:
1. Route lightbar power cables as close to vehicles power source (battery) as possible.
2. Connect the 18AWG BLACK wire to the factory chassis ground right next to the battery.
3. Install a maximum of 15Amp Fuse (customer supplied) to the end of the RED wire of the Lightbar Power Cable.
a. Remove the fuse before connecting any wires to the battery.
b. DO NOT USE CIRCUIT BREAKER OR FUSIBLE LINK.
4. Connect the other end of the Fuse to the POSITIVE (+) terminal of the battery.
a. Do NOT use any more than 2ft of wire between the battery terminal and the fuse and ensure the wire is protected and secured from being
cut into; this is non-fused wire.
Control Wire Connections:
Based on required functions of the lightbar, connect the following wires to switches capable of providing +12V at a minimum of 10A to the 1 or 2
control wire harness.
Amber Only Lightbar, 3 Conductor Cable
Wire Color
Gauge
RED
18AWG
(+10-30Vdc) Warning Flash
YELLOW
18AWG
BLACK
18AWG
Warning Flash Pattern Configuration:
a. Apply power to product
b. Connect RED wire to (+) Power & BLACK wire to (-) Ground
c. Momentarily connect Pattern Select wire to (+) Power for 1 second to change the flash pattern per table below
d. State is programmed upon releasing the pattern select wire from (+) Power
fpm=Flashes per Minute
fps=Flashes per Second
#
Phase
1
Sim
Alt In/Out, Alt L/R, Sim
2
Sim
3
Sim
4
Alt L/R, Sim
5
Alt L/R, Sim
6
Sim
7
Alt L/R, Sim
8
Alt L/R
9
Alt In/Out
10
IMPORTANT
WHEN PASSING CABLES THROUGH FIREWALL OR OTHER
SHEETMETAL, INSERT GROMMET TO PROTECT THE CABLE!
ALL CUSTOMER SUPPLIED POWER WIRES CONNECTING TO THE POSITIVE (+) OR NEGATIVE (-) BATTERY
TERMINAL OR LOCAL CHASIS GROUND (-) MUST BE SIZED TO SUPPLY AT LEAST 125% OF THE MAXIMUM
CURRENT AND PROPERLY FUSED AT THE POWER SOURCE WITH APPROPIATELY RATED FUSE.
4.
Wire Functions
(+) Pattern Select
(-) Ground
FLASH PATTERNS
Pattern
Single Flash (SAE/ECE)
Combination Single/Triple Flash
Combination Single/Quint Flash
Combination Single/Triple/Quint Flash
Combination Single/Warp/Quint Flash
Triple Flash
Triple Flash
Combination Single/Triple Flash
Triple Flash
Triple Flash
Route wires only in locations that are not subjected to
potential wear. Make sure to avoid routing wires in the
deployment area of your air bag. Refer to your vehicle's
owner's manual for airbag deployment zone.
WARNING
!
Amber with White Work Lights, 4 Conductor Cable
Wire Color
Gauge
RED
18AWG
WHITE
18AWG
YELLOW
18AWG
BLACK
18AWG
fps
fpm
125
2.1
54
0.9
54
0.9
43
0.7
0.5
27
WARNING
!
Wire Functions
(+10-30Vdc) Warning Flash (Amber Color Only)
(+10-30Vdc) Takedown/Work Lights
(+) Pattern Select
(-) Ground
Default
SAE
CA
Compliant
Y
Series 2Xwith3or4WiresAndBlackTops 1017
Publicidad
