Storage; Display Error Codes - Predator D12 Manual De Instrucciones

If the dehumidifi er will not be used for a long period of time, take the following steps:
1- Remove the plug from the socket and empty the tank, make the tank and the dehumidifi er dry completely, this
may take a couple of days.
2- Clean the air fi lter .
3- Check the dehumidifi er for perfect condition to ensure a safe use of it after a long period of storage.
4- Pack the device with the suitable packaging.
5- Store the dehumidifi er in a dust-free and out of direct sunlight location, preferably covered with a sheet of
plastic.
Please contact local distributor if any of the error codes below appears.
Display Code
Error
Display
What is happening
www.glaziar.com / info@glaziar.com
3 . Remove the pre-fi lter, clean the fi lter with a vacuum cleaner or soapy water no
hotter than 40°C.
4. Rinse and dry the fi lter completely before installing back to the device.

STORAGE

DISPLAY ERROR CODES

E1
Temperature sensor error
Flash every 30 seconds
Machine works normally Machine works normally, but
E2
Humidity sensor error Air inlet temperature is too
Flash every 30 seconds
Compressor stop working,
can't set the humidity
speed. 10mins later, if the
temperature decrease to
below 40
L3
Air inlet temperature is too
0
high>42 C
Slowly fl ash L3
Compressor stop working,
fan works at low fan fan works at low fan
speed. 10mins later, if the
temperature increase to
0
C, machine will above 2
work normally.
L4
0
low<0 C
Slowly fl ash L4
0
C, machine will work
normally
30