Vision Fitness T600 Manual Del Usuario página 6

IMPORTANT: Do not tighten bolts until step 3 is complete.
1
• Remove 2 pre-installed screws (A) and detach MOTOR COVER (1).
• Open HARDWARE FOR STEP 1.
• Attach LEFT CONSOLE MAST (3) to BASE FRAME (2) using 4 BOLTS (B)
and 4 FLAT WASHERS (C) from the top and bottom.
• Attach RIGHT CONSOLE MAST (6) to BASE FRAME (2) using 4 BOLTS (B)
and 4 FLAT WASHERS (C) from the top and bottom.
NOTE: Be careful not to pinch wires while attaching the handlebar.
Hardware For Step 1
Description
A Pre-installed Screw
B Bolt
C Flat Washer
A
3
B
C
6
Qty
2
8
8
1 6
2
• Open HARDWARE FOR STEP 2.
2
• Connect the HEART RATE GRIP WIRE (12), discard the wire tie, and tuck the cables
inside the LEFT HANDLE BAR (8) and slide into the CONSOLE BASE (9).
• Connect the HEART RATE GRIP WIRE (13), discard the wire tie, and tuck the cables
inside the RIGHT HANDLE BAR (10) and slide into the CONSOLE BASE (9).
• Attach HANDLEBARS (8 & 10) to CONSOLE BASE (9) using 4 BOLTS (E) and 4
CURVED WASHERS (F).
Hardware For Step 2
Description Qty
E Bolt 4
F Arc Washer 4
9
12
F
E
8
13
10