Wiring To Power Supply - KOBE CH7630SQB Intrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1. Using
references
Measurements and Diagrams on pages 19-21,
mark the leveling point of the hood. Position
two mounting screws (not provided) on the
wall, leaving 1/8 space away from the wall.
2. Puncture the knockout wire access hole at
the back of the hood and draw the electrical
wires through as shown in Figure 12.
3. Align hood-mounting bracket to the screws on
the wall and hook hood into place as shown in
Figure 13. Tighten screws to secure hood to
the wall.
4. For safety purpose, pre-drilled mounting holes
are provided through the back of the hood.
For a more secure installation, use as many
mounting holes as needed to secure from the
inside
of
hood
CAUTION
: MAKE SURE HOOD IS
SECURE BEFORE RELEASING.
Wiring to Powe r Supply
6$)(7< :$51,1*
RISK OF ELECTRICAL SHOCK. THIS RANGE
HOOD MUST BE PROPERLY GROUNDED.
MAKE SURE THIS IS DONE BY QUALIFIED
ELECTRICIAN IN ACCORDANCE WITH ALL
APPLICABLE
NATIONAL
ELECTRICAL
CODES.
CONNECTING WIRES, SWITCH POWER OFF
AT SERVICE PANEL AND LOCK SERVICE
PANEL TO PREVENT POWER FROM BEING
SWITCHED ON ACCIDENTALLY.
5. Connect the electrical wires.
-
Connect three wires (black, white and
green) to house wires and cap with wire
connectors. Connect according to color:
black to black, white to white, and green
to green as shown on Figure 14.
-
Store wires in the wiring box.
in
TABLE
1
(screws
not
provided).
AND
LOCAL
BEFORE
and
Figure 12
Figure 13
Figure 14
10
WALL

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ch7636sqbCh7642sqbCh7648sqb

Tabla de contenido