Motorola T605 Manual Del Usuario página 12

1 Disconnect the vehicle's battery.
2 Remove all fuses from the power adapter cable and tape
them to their respective holders. DO NOT re-insert fuses
until you complete and inspect all connections.
3 On the power adapter cable, cut off the white 8-pin
connector as close to the connector as possible. Be sure
to leave the inline fuses on the cable along with enough
spare length of wire to allow connections to be made.
Dispose of the connector.
4 Connect the power adapter cable's GREEN Ignition
Sense wire (3 Amp fuse) to an ignition-switched location
on the fuse block. When the ignition is off, the ignition
sense line should be low.
5 Connect the power adapter cable's YELLOW
Entertainment Mute Wire to the vehicle's entertainment
system's mute input.
Note: This feature is only usable if the vehicle's
entertainment system supports an active low, single
wire, radio mute signal. Otherwise, the installation may
require an optional relay adaptor (not included) or other
customization.
6 Connect the power adaptor cable's RED positive primary
lead (4 amp fuse) to a point in the vehicle's fuse box that
is fused at 4 to 5 amps. The RED positive primary lead
should be powered continuously. On/Off switching is
performed by the GREEN Ignition Sense wire.
Important: Do not connect the RED and GREEN wires
together. Doing so limits the functionality of the car kit.
10 Installing the Handsfree Car Kit