monzana DBDL006 Manual Del Usuario página 11

1
Press
Pull to open
2
Nail tips touching
the guide rails
"F" nail 18Ga.
Press
against the
front part
3
Staples 18Ga.
WARNING: Point the device away from yourself
and from others when you are loading. Mistakes
can lead to a risk of injury. Do not load the device
when making contact with the work surface as
this may cause injury.
Removing nails:
1. Disconnect the compressed air supply.
2. Press the magazine cover and remove the
magazine.
3. Grasp the strips of nails from the top and
remove them from the magazine.
Methods for use
The device is equipped with a retainer. It can only
be triggered when the retainer is pushed down.
The device works with contact actuation.
CAUTION: To avoid double firing or unwanted
firing through rebound:
• Do not press the device against the wood using
excessive pressure.
• In the event of rebound, break contact between
the device and the wood.
1. Pull the trigger without the device touching
the work surface.
2. Press the retainer against the work surface to
fire a nail.
3. Moving the device along the work surface
with wave-like movements against the work
surface. Every time you make contact with
the surface, a nail will fire. Once the desired
number of nails have fired, take your finger off
the trigger.
NOTE:
Handle nails and packaging carefully! The
nail binding may break if handled improperly,
resulting in misfeeds and jamming.
After nailing has finished:
1. Disconnect the compressed air connection.
2. Remove all nails.
3. Drip 5-10 drops of pneumatic oil (air lubricator)
into the air inlet connection point on the
device.
4. Empty the fluid reservoir on the compressor.
Use in cold weather
CAUTION: Do not use the device in freezing
conditions. The device must be completely
thawed before use. Frozen moisture can impair
the function of internal components and lead to
increased risk of injury or damage to the device.
www.Deuba24online.de
In cold conditions, the driving speed of the device
is reduced, particularly for the first nails that
are fired. Once the device has warmed up, the
operating speed will increase. Keep the device
warm to prevent reduced work performance.
Setting the operating depth
CAUTION: Every time you change a setting on the
device, disconnect it from the compressed air
hose! This precaution helps to prevent the device
from unintentionally firing.
1. Disconnect the device from the compressed air
supply.
2. Remove all nails.
3. Setting the operating depth :
• To reduce the operating depth, turn the knob
anti-clockwise;
• To increase the operating depth, turn the
knob clockwise.
4. Load the nails as described above.
5. Connect the device with the compressed air
hose.
Too deep
Too high
20 21 www.Deuba 24onl i ne.d e
Adjusting the air outlet
The direction of the exhaust duct can be changed
by turning the cover.
Nail indicator
A red indication shows when the device should
be loaded again. Then the device is loaded with
a strip of nails, the indicator is not visible. If the
nails are used up, the indicator will light up.
The unit should be recharged when half the red
indication level is visible.
Nail indicator
Flush
Using the no-mar tip
CAUTION: When changing the no-mar tip, make
sure you are not pressing the trigger and the
device is disconnected from the compressed air
supply.
Flush
If you wish to protect the work surface from
scratches, fit the supplied no-mar-tip accessory
to the retainer.
Changing the no-mar-tip:
1. Disconnect the air hose from the device.
2. Fit the no-mar-tip to the base of the retainer.
To remove the no-mar tip, simply pull it off.