POWER SMITH ASH VACUUM Manual Del Operador página 10

4. Insert the power cord plug into an outlet near the area to be vacuumed, then push the switch to the "I"
(ON) position.
THE ATTACHMENTS
This Ash Vacuum comes with a set of attachments- Crevice Tool, Brush Nozzle and Pellet Stove Hose- to
clean tight spaces, troughs, seams and pockets in Pellet Stoves, Wood stoves, Fireplaces, and BBQ grills.
WARNING:
ashes are completely cold before using the attachements.
WARNING:
performing all maintenance procedures and when removing the motor housing.
IMPORTANT!
indoors in or near living areas.
CLEANING THE CANISTER AND FILTER
1. Unplug the vacuum from the power outlet.
2. Remove the hose from the vacuum port by rotating the hose coupling counter-clockwise.
3. Unclamp the motor housing and remove it from top of the canister.
Filter Cleaning
1. To minimize airborne dust, tap the inside of the filter bag with your fingertips to knock collected dust
into the canister.
2. Remove the filter bag from the canister and remove remaining dust by tapping the filter's interior or
lightly brushing off the outside of the bag.
NOTE:
3. If necessary, the filter may be hand washed with cool water & mild detergent, then gently
hand wring to remove excess water and set aside to air dry. Be sure the filter is dry before use.
DO NOT machine wash/dry the filter!
NOTE
4. : Do not use compressed air to clean the filter.
Canister Cleaning
1. Dump the cold ash from the canister into an appropriate disposable container such as a plastic or
paper trash bag.
2. To remove ash clinging to the canister interior, lightly wipe off the dust with paper towels or cloth rag.
If necessary, a slightly moist towel or rag may be used to wipe off the canister interior & exterior.
3. Do not wash the canister with water, cleaning agents, or other liquids.
Inspect the filter for tears or holes; if any are found, replace the filter before reassembly of the Ash
Vacuum.
IMPORTANT!
properly installed filter; doing so will result in dust blowing out the vents & exhaust
port.
Following canister & filter cleaning, and then filter inspection and filter replacement, if necessary,
reassemble the Ash Vacuum before storage.
The attachments are used for COLD ASH ONLY. Make sure the
MAINTENANCE
Always disconnect the plug from the power outlet before
All cleaning and maintenance procedures should not be done
Do not use the vacuum with a damaged filter or without a
English
10