On/Off Switch - POWER SMITH ASH VACUUM Manual Del Operador

Although the Ash Vacuum has special features for vacuuming warm & cool ashes from fireplaces, stoves,
and BBQ's, it may also be used for dry vacuuming as a shop/garage vacuum, a household vacuum, or as a
blower. In the Operation section are special instructions for various ash vacuum uses.
WARNING:
warnings. Safety is a combination of common sense, staying alert, and knowing how
your Ash Vacuum works.
WARNING:
in areas with flammable gases, vapors or explosive dust in the air. Flammable gases
or vapors include but not limited to: lighter fluid, solvent type cleaners, oil-base
paints, gasoline, alcohol or aerosol sprays. Explosive dusts include but are not
limited to: coal, magnesium, aluminum, grain or gunpowder. Do not vacuum explosive
dust, flammable or combustible liquids or hot ashes. To reduce the risk of health
hazards from vapors or dusts, do not vacuum toxic materials.

ON/OFF SWITCH

After plugging the power cord into an outlet, the unit is turned on by pushing the switch from position "O"
to position "I". The symbols used on the toggle switch are international "On & Off" symbols. "O" is the
symbol for "OFF" and "I" is the symbol for "ON".
NOTE:
Static shocks are common in dry areas or when the relative humidity of the air is low.
Vacuuming fine debris with your Ash Vacuum can cause static charge on the hose or on the vacuum.
There is a static discharge chain underneath the canister to reduce the static charge. In the case
there are still static shocks, make sure the ash vacuum is placed on a concrete ground and the static
discharger chain is touching the ground. The other remedy to reduce the frequency of static shocks in
your home when using this vacuum is to add moisture to the air with a humidifier.
ASH VACUUM USE
1. Before connecting the power cord to power source, check that the vacuum is properly assembled with
the metal nozzle installed.
CAUTION
: NEVER vacuum the ash without the metal nozzle in place.
2. Ensure the On/Off switch is in the "O" (OFF) position.
3. Place the Ash Vacuum near the fireplace or stove you are cleaning and make sure the ash inside is
cool.
4. Insert the power cord plug into an outlet near your work area and push the switch to the "|" (ON)
position.
5. Using the metal nozzle only, begin vacuuming the ash.
6. As you vacuum, constantly check the nozzle, hose, canister, filter and motor for excessive
temperatures. If you notice an increase in temperature, turn off the vacuum immediately. Unplug the
vacuum and remove the vacuumed material from the canister and filter bag. Allow the vacuum and the
material to be vacuum to cool before continuing to vacuum.
IMPORTANT!
canister fills with ash. Check it regularly to see if the vacuum canister is full.
OPERATION
Be sure to read, understand and apply all safety instructions and
To reduce the risk of fire or explosion, do not operate this vacuum
O = OFF
The FULL indicator area will gradually become RED as the
English
I = ON
8