Installing The Casters - POWER SMITH ASH VACUUM Manual Del Operador

ASSEMBLY INSTRUCTIONS
WARNING:
until all assembly steps are complete and you have read and understood the safety
and operation instructions. Do not operate the vacuum with any parts damaged or
missing.

INSTALLING THE CASTERS

1. With the motor housing removed and vacuum canister empty, turn canister over (upside down) so the
black base is now on top. Be sure the canister is not resting on the clamps. See figure 2.
2. Locate the small diameter hole in a corner of the base and insert the caster stem into the hole. Using
firm and steady pressure, press the caster downward until it will go no further. See figure 2.
3. Repeat Step 2, installing a caster in each of the remaining 3 corners of the vacuum base.
4. Turn the canister over so that canister and base are now resting on the four installed casters. The unit
should rest evenly on the 4 casters; if not, one or more casters is not completely inserted.
INSTALLING THE FILTER, MOTOR AND HOSE
1. The filter bag used in your ash vacuum utilizes a special two-part construction giving it 2 (two) distinct
surfaces. The outer surface of the filter is smooth with a silver like shiny appearance, while the inner
surface has a gray woven fabric look.
2. Lower the filter bag into the metal canister with the shiny silver surface facing outward and rubber
gasket at the top. See figure 3.
3. Lower the filter until the rubber gasket rests evenly on the lip of the metal canister.
4. If necessary, adjust the rubber gasket so it completely covers the canister lip without any gaps.
5. Insert the motor housing into the canister so it rests on top of the rubber gasket with the on/off switch
and FULL indicator above the canister vacuum port.
IMPORTANT
the motor housing as shown in figure 4.
6. Secure the motor housing in place by locking down the clamps.
7. Align the raised boss on the large hose end with the gap at the top of the canister vacuum port. Push
the hose end inward and rotate clockwise to lock in place. See figure 5.
8. Insert the metal intake nozzle into the other end of the hose. Turning the nozzle clockwise while
pushing it into the hose end will help to securely seat the metal nozzle.
INSTALLING THE ATTACHMENTS (FIG 7)
1. Connect the large end of the adaptor (17) to the ash vacuum hose (12) as shown in figure 7.
2. Connect the attachment (14, 15 or 16) to the small end of the adaptor (17).
For your own safety, never connect plug to power source outlet
!
Be sure each clamp end is aligned over a clamp landing on
English
6