How To Put The Charging Operation On Hold; How To Perform Repeated Charges Of The Same Amount - Inficon WEY-TEK Manual Del Usuario

4. Start the charging operation by pressing the Charge/Hold button. You will hear
the internal solenoid valve click open and refrigerant will flow. The display will
flash "CHRG" on the bottom line of the LCD display next to the programmed
target charge amount. The top line of the display will zero when the
Charge/Hold button is pressed and will show the actual amount of refrigerant
transferred as refrigerant flows through the Charging Module. When the
programmed target charge amount is reached, the solenoid will close, you will
hear two short beeps, and the display will alternately flash "Charge Complete"
and the programmed target charge amount.

How to put the Charging Operation on Hold

Once the charging operation has begun, you can pause it at any time by pressing
the Charge/Hold button once. The solenoid valve will close, stopping the
refrigerant flow, and you will hear one short beep. The display will flash "HOLD"
and the programmed target charge amount on the bottom line of the display.
Press the Charge/Hold button again when you are ready to resume charging.
How to put the Charging Operation on Hold and use the
Wey-TEK and Charging Module in scale mode
If you need to measure a refrigerant cylinder while the charging operation is on
hold, you can easily put the scale and charging module into weight scale mode
temporarily. After you have put the Charging Operation on Hold, press the
Tare/Clear button once. This will put the unit into weight scale mode. The top line
of the display will show the weight based on the last time the scale was zeroed.
Place the new tank on the weighing platform and its actual weight will be
displayed. If you wish, press the Tare button again to zero the scale to the weight.
When you are ready, press the Charge/Hold button to resume charging from the
amount already transferred. You will hear one short beep when charging resumes.

How to Perform Repeated Charges of the Same Amount

The last programmed target charge amount will be automatically saved in the
Charging Module's memory. If you would like to repeat the same charge amount,
simply press the Charge/Hold button once again to start a new charging cycle
using the previously programmed target charge amount.
7