Technical Data - Zanussi ZWT 71401 WA Manual De Instrucciones

B
To align the door perfectly, loosen the screw,
adjust the door and tighten the screw A again.
The appliance is prearranged for a magnetic
closure of the door. To enable a correct
operation of this device, screw the counter-
magnet A (steel disk + rubber ring) into the
inner side of the door.
Its position must correspond to the magnet B
on the appliance.
Do not remove the screw C !

Technical Data

Dimension
Electrical connection
www.zanussi.com
A
A
B
C
Width/ Height/ Depth/ To-
tal depth
Voltage
Overall power
Fuse
Frequency
If the door has to be opened from left to right,
invert the position of the plates E, the magnet D
and the plate C.
Mount the counter-magnet D and the hinges A
as previously described.
Do not remove the screw B!
E
596 mm/ 820 mm/ 544 mm/ 544 mm
220-230 V
2000 W
10 A
50 Hz
D
A
C
B
25