Electrochemical Cleaning And Regeneration Center; Chemical Cleaning: Oxygen And Ozone Sensor Cell; Membrane Support Cleaning - Hach ORBISPHERE 31 Serie Manual De Instrucciones

Electrochemical cleaning and regeneration center

The ORBISPHERE 32301 is a very efficient cleaning and regeneration tool for electrochemical
sensors. This tool reverses the electrochemical process that is taking place in the sensor cell during
normal operation. This removes oxidation and at the same time regenerates the surface of the
electrodes. In addition, the regeneration center offers a continuity tester for checking the sensor
electronics.
Use of this tool is recommended for a noticeably extended sensor life. Detailed information on how to
use the cleaning and regeneration center is included in the 32301 Operator Manual.
Note: It is mandatory to use the 32301 Sensor Cleaning and Regeneration Center for servicing electrochemical H
sensors. This process is called dechloridization and rechloridization of the electrodes (see
cleaning on page 15).

Chemical cleaning: oxygen and ozone sensor cell

Note: Not applicable for H
The following supposes that the sensor has been taken apart. For disassembly and assembly
procedures, see Disassembly and assembly
Conditions
Wear on the membrane, and chemical reactions within the sensor, requires that the sensor be
serviced regularly to restore its original sensitivity. Service includes electrode cleaning and
membrane replacement. A clear sign that a sensor maintenance is required is when measurements
are noticeably less stable than usual, and when a calibration does not improve the situation.
Method description (see following step-by-step procedure)
• Electrochemical cleaning with 32301 (if available)
... when not available or results are insufficient:
• Anode and cathode chemical cleaning
• Central electrode polishing
• Final rinsing
Note: To eliminate any silver residue that ammonia cleaning cannot remove, it is sometimes required to repeat the
chemical cleaning using nitric acid (HNO

Membrane support cleaning

1. Empty and rinse the electrolyte reservoir under tap
water.
2. Rinse membrane support under water and wipe it
dry.
3. Check for the presence of any residue on the
surfaces. Residue can be removed by placing the
support in a container of nitric acid (HNO
70% by weight) until it recovers its original
appearance (normally within 30 seconds).
4. Rinse one minute under tap water and check again
for surface cleanliness.
Nitric acid is dangerous! Please refer to the safety information from your chemical supplier.
sensors.
2
, not over 70% by weight).
3
, not over
3
C A U T I O N
on page 10.
2
Hydrogen sensor cell
English 13