La-Z-Boy Reclina-Way Instrucciones De Operación página 6

La-Z-Time Motion Upholstery and La-Z-Time
®
Motion-Modulars
WARNING
– To reduce the risk of injury:
• Do not operate the unit until the back is installed and locked.
1. Install the backs, if applicable (some styles come with the backs installed).
• Lay the back on the seat. Lift the back at a slight angle and align the brackets inside the back
with the brackets on the body (F
IGURE
• Lower the back onto the body, making sure the back and body brackets are completely engaged.
• To make sure the back is properly installed, lift the back upholstery cover to visually confirm
that both sets of back and body brackets are engaged (F
• If you are unable to install the back properly contact your La-Z-Boy
• Lock the brackets by using a screwdriver to push down the locking levers (F
• Pull the outside back upholstery cover down tight. Firmly press the fastening tape on the outside
back upholstery cover to the fastening tape on the bottom of the rear rail (F
WARNING
– To reduce the risk of serious injury:
• Provide a clear path for operation of the back and legrest. Place tables and area rugs at
a distance to allow the legrest to fully extend without rubbing or interference.
2. Place units in the desired location.
3. Adjustable glides are provided on units with metal base rails. Make sure the glides are adjusted
to a height that provides a clear path for operation of the legrest (see Furniture Placement Guide).
• Each glide is attached to the base rail by one jam nut and one lock washer on top of the front
attachment bracket or base rail, and one jam nut on the bottom of the base rail (F
Motion-Modular unit featured). Loosen the jam nut located on top of the front attachment
bracket or base rail.
• Holding the top jam nut, turn the glide clockwise to lower the unit or counterclockwise to raise the unit.
• Tighten the bottom jam nut to the base rail, then tighten the top jam nut to the lock washer on top of
the front attachment bracket. Make sure both jam nuts are tight to prevent the bracket from rotating
on the base rail.
• Repeat this step for each adjustable glide, if necessary.
4. Motion sofa or chair assembly is complete. If assembling modular units, proceed to the following page.
10
Assembly Instructions
®
1).
2).
IGURE
® dealer for assistance.
3).
IGURE
1 and F
IGURE
IGURE
La-Z-Time
Motion-Modulars
F 1
IGURE
Fastening Tape
4).
IGURE
F 3
IGURE
Back
Bracket
5,
F 5
IGURE
Lock Washer
Bracket
Attachment
Lower
Jam Nut
Adjustable
Glide
Motion Upholstery and La-Z-Time
®
Assembly Instructions
®
Fastening Tape
Back
Bracket
Body
Bracket
Locking
Lever
Locked
Position
Upper Jam Nut
Base Rail
F 2
IGURE
F 4
IGURE
11