Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
Intended Use
The machine is intended for impact drilling
in brick, concrete and stone as well as for
drilling in wood, metal and plastic.
1. AUXILIARY HANDLE (see A)
Slide the handle onto the drill and rotate to the
desired working
position. To clamp
the auxiliary
handle rotates
the handgrip
clockwise. To
A
loosen the
auxiliary handle
rotates the handgrip anti-clockwise. Always use
the auxiliary handle.
2. INSTALLING THE DEPTH GAUGE (See A)
The depth gauge can be used to set a constant
depth to drill. To use the depth gauge, loosen the
handle by rotating the bottom section of handle
anti-clockwise. Insert the depth gauge through
hole in handle. Slide the depth gauge to required
depth and tighten fully.
3. CHUCK ADJUSTMENT (see B)
To open the chuck jaws rotate the front section
of the chuck while holding the rear section. Insert
the drill bit between the chuck jaws and rotate
the front section
in the opposite
direction while
holding the rear
section. Ensure
that the drill bit is
in the center of
B
the chuck jaws.
Finally, firmly rotate the two separate chuck
sections in opposite directions. Your drill bit is
now locked in the chuck.
4. ON/OFF SWITCH
Depress the switch to start the tool and release it
to stop your tool.
5. SWITCH LOCK-ON BUTTON (see C)
Depress on/off switch then lock-on button,
release on/off
switch first and
lock-on button
second. Your
switch is now
locked on for
C
continuous use.
To switch off your
tool just depress and release the on/off switch.
6. VARIABLE SPEED SWITCH (see D)
Adjust the variable speed switch to increase
or decrease the
speed according
to the material
and accessory
to be used (also
possible during no
D
load operation).
Low speed will
provide low torque and high speed gives higher
torque.
7. FORWARD AND REVERSE ROTATION
CONTROL (see E)
For drilling use
forward rotation
marked "
"
(lever is moved to
the left). Only use
reverse rotation
marked "
"
F
(lever is moved to
the right) to release a jammed drill bit.
NOTE: Never move the forward/reverse
switch whilst the drill in operation or the on/
off switch is locked as this will damage the
drill.
8. HAMMER OR DRILLING CONTROL (3) (see F)
When drilling masonry and concrete choose the
hammer position "
". When drilling
wood, metal,
plastic, choose
the drill position.
"
".
E E
31
Publicidad
