Additional Information; Troubleshooting - Pioneer VSX-520 Manual De Instrucciones

Additional information

Chapter 9:
Additional information

Troubleshooting

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble may lie
in another component. Investigate the other components and electrical appliances being used.
If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest
Pioneer authorized service center or your dealer to carry out repair work.
• If the unit does not operate normally due to external effects such as static electricity
disconnect the power plug from the outlet and insert again to return to normal operating
conditions.
Problem
The power does not turn
on.
No sound is output when a
function is selected.
No image is output when a
function is selected.
Considerable noise in radio
broadcasts.
Remedy
• Disconnect the power plug from the outlet, and insert again.
• Make sure there are no loose strands of speaker wire touching the rear
panel. This could cause the receiver to shut off automatically.
• If the power shuts off automatically, take the unit to your nearest
Pioneer authorized service center or your dealer for servicing.
• Make sure the component is connected correctly (refer to Connecting
your equipment on page 16).
• Press MUTE on the remote control to turn muting off.
• Press SIGNAL SEL to select the proper input signal (see Choosing the
input signal on page 36).
• Make sure the component is connected correctly (refer to Connecting
your equipment on page 16).
• Select the correct component (use the MULTI CONTROL buttons).
• Check The Input Assign menu on page 40 to make sure you're assigned
the correct input.
• The video input selected on the TV monitor is incorrect. Refer to the
instruction manual supplied with the TV.
• Connect the antenna (page 25) and adjust the position for best
reception.
• Route any loose cables away from the antenna terminals and wires.
• Fully extend the FM wire antenna, position for best reception, and
secure to a wall (or connect an outdoor FM antenna).
• Connect an additional internal or external AM antenna (page 25).
• Turn off equipment causing interference or move it away from the
receiver (or move antennas farther away from equipment causing noise).
09
47
En