Van Gerven Eco Switch Manual De Instrucciones página 4

Eco Switch
Please read through these instructions for use carefully before installing this device.
Key
10
sec
Operation
The Eco Switch is the ideal switch for switching two electrical devices for your pond, such as two pond pumps. This is a good alternative to a
high-frequency pump. The same energy-saving result can be obtained by controlling a heavy and a lighter pond pump with the Eco Switch. A
pond pump is usually switched on 24 hours a day in order to circulate the pond water through the filter. If you are using a heavy pump that has
a throughput of many litres of water per hour, this pump will consume a great deal of electricity 24 hours a day. It is possible to save a lot of
energy by switching from a heavy to a light pump at set times during the day and/or night.
But the Eco Switch can, of course, also be used for other devices.
The Eco Switch us very easy to install thanks to the compact design. The operating times can be set once using the button on the display. If the
power cord is unplugged from the mains socket, the operating times settings that you have entered will be stored in the Eco Switch. After a
power cut, you only need to set the current time again.
Advantages of the Eco Switch:
• Energy-saving
• The pump switch can be adjusted separately for each hour
• Easy installation
• Compact design
• Easy to combine
• 2-year guarantee on manufacturing faults
• Earthed
Safety
- Always insert the plug of the device into a socket fitted with a protective cover.
- Always comply with the electricity company's regulations with regard to any permanent connection to the mains. If there is any doubt
regarding the connection, consult a recognised electrician or the electricity company. Always work with an earth leakage current circuit-
breaker (max. 30mA).
- Always remove the plug from the socket before carrying out any maintenance or repair work on the unit. Never insert the plug / pull the
plug from the socket when you are standing in water or if your hands are wet.
- This device is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or a lack of
experience and know-how, unless they are under supervision or are instructed on the use of the device by a person responsible for their
safety.
- The cable of the device cannot be replaced. Never remove the plug, but always leave the electrical unit intact. An electrical unit with the
plug removed will no longer be covered by the guarantee.
4
press briefly
press for 3 seconds
do not do anything for 10 seconds
selection confirmed
time of day
setting the pumps
setting the timer
pump 1
pump 2
EN