Electric Installation; Pre-Operation - Skymsen LAR-15LMB Manual De Instrucciones

2.1.2. Electric Installation

This equipment was developed to work on a 220 V (60Hz) power supply. Always check the
voltage indicated on the electric cord of the equipment to make sure it is the appropriate.
The electric cord brings a plug with 3 (three) pins, one of them is for grounding the
equipment. It is mandatory that all the 3 (three) pins are properly connected before
turning the equipment on.
Make sure the voltage of the power supply is compatible with the voltage
Avoid plugging this equipment in an extension cord or plug adapter.

2.2. Pre-Operation.

Before using the Tilting Blender, you must wash with water and neutral soap all the
parts that get in contact with the products to be processed (read item 3.4 Cleaning and
Sanitization).
Check if the equipment is firm upon its working place.
2.2.1 Cup Placement
The cup brings an efficient tilting system allowing the cup to be placed simply and safely .
To tilt the Cup follow the below instruction :
Switch off the blender pressing the OFF Switch to position "O" No. 04 (Pic. 01)
Remove the Lid No. 01 (Pic. 01)
Hold tightly the Cup handle and with your foot press the Pedal No. 01 (Pic. 03) getting free
the tilting Cup.
Move the Cup and get the product off .
Move back the Cup until to be locked on to vertical position.
IMPORTANT
indicated on the electric cord label.
IMPORTANT
7