Preparation For Mounting; Assembly - HAMPTON BAY Havana Guía De Uso Y Cuidado

Assembly - Standard Ceiling Mount
1

Preparation for mounting

□
Remove the canopy ring from the canopy (C) by turning the
ring to the right until it unlocks.
□
Remove the slide-on mounting bracket (A) from the canopy
by loosening the four screws on the top of the canopy (C).
□
Remove the two non-slotted screws and loosen the
slotted screws. This will enable you to remove the slide-on
mounting bracket (A).
3
Assembling the fan
□
Loosen, but do not remove, the setscrew on the collar (K) on
top of the fan-motor assembly (D).
□
Align the holes at the bottom of the ball/downrod assembly
(B) with the holes in the collar (K) on top of the fan-motor
assembly (D).
□
Carefully insert the hanger pin (CC) through the holes in the
collar (K) and ball/downrod assembly (B). Be careful not to
jam the hanger pin (CC) against the wiring inside the ball/
downrod assembly (B).
□
Insert the locking pin (DD) through the hole near the end of
the hanger pin (CC) until it snaps into its locked position.
□
Re-tighten the setscrews on the collar (K) on top of the
fan-motor assembly (D).
WARNING: Failure to properly install the locking pin could
result in the fan becoming loose and possibly falling.
2
Routing the wires
□
□
A
C
CC
7
Route the wires exiting the top of the fan-motor
assembly (D) into the decorative motor collar cover (F)
and through the canopy ring (C).
Make sure the slot openings are on top and route the
wires through the canopy (C) and then through the ball/
downrod assembly (B).
Please contact 1-877-527-0313 for further assistance.
C
B
F
D
B
DD
K
D
HAMPTONBAY.COM