How To Assemble Your Ceiling Fan (Downrod) - Fanimation FP9044 Serie Manual Del Usuario

How to Assemble Your Ceiling Fan (Downrod)

1. Remove and discard the five rubber motor stops
from the motor assembly by removing the screws.
(Figure 1)
2.
Remove the hanger ball portion from the downrod/
hanger ball assembly by loosening the set screw in
the hanger ball until the ball falls freely down the
downrod. Remove the pin from the downrod, then
remove the hanger ball. Retain the pin and hanger ball
for reinstallation in Step 7. (Figure 2)
3. Remove the hairpin clip and clevis pin from the
bottom of downrod. Retain the pin and clip for
reinstallation in step 5. (Figure 3)
4.
Loosen the two set screws and locking nuts in the
downrod support of the motor assembly. Route the
black, white, blue wires and safety cable through the
downrod. (Figure 4)
5. Slide downrod into the downrod support on top of
the motor. Install the clevis pin by aligning the holes
in the downrod support with holes in the downrod.
Secure clevis pin with hairpin clip. Tighten the two set
screws with nuts in the downrod support. (Figure 5)
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in the
fan falling.
Motor Stops
Downrod
Set Screw
Hairpin Clip
Downrod
Clevis Pin
7
Figure 1
Pin
Hanger Ball
Figure 2
Clevis Pin
Figure 3
Black, White, Blue
wires and Safety Cable
Downrod
Figure 4
Set Screws and
Locking Nuts (2)
Hairpin Clip
Figure 5