Complete The Installation - Kohler K-705800 Guia De Instalacion

Bumper
Side Panel
Frame

14. Complete the Installation

Attach the Bumpers and Kohler Logo
Install one bumper on the edge of the side panel frame as shown.
If applicable, install the KOHLER logo on the center of the threshold (not shown).
Apply Sealant
IMPORTANT! Carefully follow the silicone sealant manufacturer's instructions for application and curing
time.
NOTE: Thoroughly clean and dry all surfaces where silicone sealant will be applied.
Use masking tape to protect areas adjacent to those where the sealant is being applied.
Apply a bead of silicone sealant to the outside and inside of the vertical joints where wall jambs
meet the wall.
Apply a bead of sealant to the outside of the vertical joint between the wall jamb and side panel as
shown.
Apply a bead of silicone sealant to the dry side of the threshold where it meets the shower ledge.
Do not apply sealant to the wet side of the threshold.
For steam door, apply a bead of sealant where the header expander meets the ceiling to create a
steam barrier.
Troubleshooting
This troubleshooting guide is for general aid only. For service and installation issues or concerns, call
1-800-4-KOHLER.
Troubleshooting Table
Symptoms
Water Leaks
1. Water leaks under the side panel.
1144162-2-B
Seal here
(inside and
outside).
Recommended Action
A. From the outside the shower, apply silicone to the joint
where the side panel meets the threshold.
18
Seal here
(steam only).
Seal here
(inside and
outside).
Seal here
(outside only).
Kohler Co.