Corsair HYDRO X Serie Manual De Instrucciones página 5

INSTALLING TEMPERATURE SENSOR PLUG
Install the enclosed CORSAIR G1/4" Temperature Sensor Plug (D) into one of the two unused G1/4" port
located on the GPU water block.
D
INSTALLING TEMPERATURE SENSOR PLUG ON Y-SPLITTER (OPTIONALLY)
Install the enclosed CORSAIR G1/4" Temperature
Sensor Plug (D) with the CORSAIR XF Rotary
Y-Splitter to any INLET/OUTLET port on the XD7
other than FILL or DRAIN ports!
D
K
5
CONNECTING THE PUMP AND USING THE INTEGRATED DIGITAL
RGB ILLUMINATION
A CORSAIR iCUE Commander PRO or Lighting Node PRO (either)
is required in order to use the integrated RGB illumination on
the XD7 RGB. CORSAIR iCUE software is used to program the
visual effects. CORSAIR iCUE Commander PRO is required
for automatic control of the pump and for monitoring the liquid
temperature using iCUE software suite.
The XD7 RGB Distro Plate / Pump Unit can be connected to the
appropriate CORSAIR controller either directly or "daisy"-chained
with other CORSAIR addressable RGB component(s).
1. Identify the correct RGB connector on the reservoir-pump unit
(Figure 1).
2. Insert the RGB connector in a CORSAIR iCUE Commander
PRO port or Lighting Node PRO port (Figure 2).
3. Download and install CORSAIR iCUE software suite from
the following website: https://www.corsair.com/icue.
Configure visual and lighting effects by following the manual
for iCUE software.
4. Connect the XD7 RGB's pump 4-pin fan connector into Fan
Port #6 on your CORSAIR iCUE Commander PRO (Figure 3).
5. Connect the XD7 RGB's temperature sensor into temperature
Port #1 on your CORSAIR iCUE Commander PRO (Figure 4).
6. Connect the XD7 RGB's main power cable by plugging in a
4-pin Molex connector from your power supply (Figure 5).
Figure 2
H
Figure 4
D
Figure 1
Daisy Chain
(to NEXT)
Direct Attach
(IN)
Figure 3
Figure 5
PSU
XD7 RGB
6
ENGLISH