Before Using For The First Time; Boiling The Water - Krups BW410831 Manual De Instrucciones

Thank you for purchasing a KRUPS kettle. Read the instructions that apply to most of
our models carefully and keep them to hand.
CAUTION: the safety precautions are part of the appliance. Read them carefully
before using your new appliance for the first time. Keep them in a place where you
can find and refer to them later on.

BEFORE USING FOR THE FIRST TIME

„ „
Remove all of the various packaging, stickers or accessories from both the inside
and outside of the kettle.
„ „
Adjust the length of the cord by winding it under the base. Wedge the cord into the
notch. (fig. 1)
„ „
Throw away the water the first two or three times you use the kettle, as it may contain
dust. Rinse the kettle and the filter separately.
1. TO OPEN THE LID:
„ „
Pull the lid locking system and it will lift up automatically (fig. 2).
„ „
To close it, press the lid down firmly.
2. PLACE THE BASE ON A FLAT, SMOOTH, CLEAN HEAT RESISTANT SURFACE.
„ „
Your kettle must only be used with the base that it is delivered with and its own
anti-scale filter.
3. FILL THE KETTLE WITH THE DESIRED AMOUNT OF WATER. (fig. 3).
„ „
You can fill it through the spout, which ensures better maintenance of the filter.
„ „
Never fill the kettle when it is on its base.
„ „
Do not fill it above the maximum level, or below the minimum level. If the kettle is
too full, boiling water may spill out.
„ „
Do not use without water.
„ „
Check that the lid is closed properly before use.
4. POSITION THE KETTLE ON ITS BASE. (fig. 4). PLUG IT INTO THE MAINS
SOCKET
When the kettle is plugged in, a beep sounds and the display lights up. The temperature
of the water is only displayed above 40°C, otherwise "LO" is displayed on the panel.
Familiarise yourself with the control panel and the various functions of the kettle by
referring to figure 6 (fig. 6):
A Luminous red dot which shows the temperature selected
B Digital panel: displays the current temperature (in degrees Celsius)
C Temperature setting button: 50°C - 60°C - 70°C - 85°C with keep hot function on
D Water purification button: long boil
E ON/OFF button: 100°C

BOILING THE WATER

Press the ON/OFF button (E).
„ „
The button will light up.
„ „
The heating cycle starts.
„ „
When the water is heating, the temperature of the water in the kettle is displayed
on the digital panel.
6
USE