Connecting The Network Cables; Preparing A Wireless Antenna; Connecting The Power Cable - Yamaha MusicCast NX-N500 Manual De Instrucciones

Connecting the network cables

3
Connect the unit to your router with a commercially-available STP network cable (CAT-5 or higher straight cable).
Select whether to use a wired network connection or a wireless network connection, depending on your network environment.
For details, refer to "Connecting to network" (p.12).
Internet
Modem
Mobile device
(such as iPhone)

Preparing a wireless antenna

4
Raise the wireless antenna on the back of the left speaker.
• Do not apply excessive force on the antenna. Doing so may damage it.
• Be sure to check the direction in which the antenna moves, and angle it
in the proper direction.
• Do not remove the antenna.
10
En
WAN
LAN
Router
Hold the base of the
antenna while raising it to
its upright position.
Network Attached
Storage (NAS)
PC
NETWORK

Connecting the power cable

5
Connect the supplied power cable to the AC IN jack on the
rear panel, and then insert the power plug into an AC wall
outlet.
Right speaker
R
L-R
LINK
R CH
AUDIO IN
AC IN
To an AC wall outlet
L
NETWORK
USB
OPTICAL
L-R
LINK
AUX IN
R CH
AUDIO OUT
AUTO
WIRELESS
OFF
CONNECT
WIRELESS
DIRECT
SOURCE
AC IN
GAIN
MIN MAX
Left speaker
Left speaker
L
NETWORK
USB
OPTICAL
LINK
AUX IN
R CH
AUDIO OUT
AUTO
WIRELESS
OFF
CONNECT
WIRELESS
DIRECT
SOURCE
AC IN
GAIN
MIN MAX
To an AC wall outlet
L-R